A network engineer is trying to modify an existing active NAT configuration on an IOS router by using the following command:

ccnp-dump
ccnp-route-dump
ccnp-route

#1

A network engineer is trying to modify an existing active NAT configuration on an IOS router by using the
following command:

(config)# no ip nat pool dynamic-nat-pool 192.1.1.20 192.1.1.254 netmask
255.255.255.0
Upon entering the command on the IOS router, the following message is seen on the
console:
%Dynamic Mapping in Use, Cannot remove message or the %Pool outpool in use,
cannot destroy

What is the least impactful method that the engineer can use to modify the existing IP NAT configuration?
A. Clear the IP NAT translations using the clear ip nat traffic * " command, then replace the NAT configuration
quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.
B. Clear the IP NAT translations using the clear ip nat translation * " command, then replace the NAT configuration quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.
C. Clear the IP NAT translations using the reload command on the router, then replace the NAT configuration
quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.
D. Clear the IP NAT translations using the clear ip nat table * " command, then replace the NAT configuration
quickly, before any new NAT entries are populated into the translation table due to active NAT traffic.

Correct Answer: B