However, the clients are not getting the DNS server address and the domain name information configured in the DHCP pool

ccna2-answer
ccna2-exam
ccna2-vlans

#1

Refer to the exhibit. A network administrator is implementing the stateless DHCPv6 operation for the company. Clients are configuring IPv6 addresses as expected. However, the clients are not getting the DNS server address and the domain name information configured in the DHCP pool. What could be the cause of the problem?
com

  1. The GigabitEthernet interface is not activated
  2. The router is configured for SLAAC operation*
  3. The DNS server address is not on the same network as the clients are on
  4. The clients cannot communicate with the DHCPv6 server, evidenced by the number of active clients being 0

Explanation:
The router is configured for SLAAC operation because there is no configuration command to change the RA M and O flag value. By default, both M and O flags are set to 0. In order to permint stateless DHCPv6 operation, the interface command ipv6 nd other-config-flag should be issued. The GigabitEthernet interface is in working condition because clients can get RA messages and configure their IPv6 addresses as expected. Also, the fact that R1 is the DHCPv6 server and clients are getting RA messages indicates that clients can communicate with the DHCP server. The number of active clients is 0 because the DHCPv6 server does not maintain the state of clients IPv6 addresses (it is not configured for stateful DHCPv6 operation). The DNS server address issue is not relevant to the problem.