Where the output will be shown of the command debug condition interface fa0/1?

ccnp-dump
ccnp-route-dump
ccnp-route

#1

Where the output will be shown of the command debug condition interface fa0/1?
A. it will show on interface f0/1
B. it will show on interface f0/0
C. both interfaces will show debugging output
D. an interface cannot be used as condition

Correct Answer: A

Explanation:
The command “debug condition interface ” command is used to disable debugging messages for all interfaces except the specified interface so in this case the debug output will be shown on Fa0/1 interface only.

Note: If in this question there was another “debug condition interface fa0/0” command configured then the
answer should be C (both interfaces will show debugging ouput).